Sun Microsystems Netra t1 100, User And Administration Manual

Page: 46 / 154

24 Netra t1 User and Administration Guide • June 2000
1. If your system is new and you have just removed it from its packaging, go straight
to Step 3.
If your system is currently in use, but you need to open it to install an option
module or replace a component, then:
a. Shut down Solaris from the console.
b. Turn the power supply switch off.
c. Disconnect the power cord(s).
d. Disconnect all other cables.
2. If you have installed the system into a rack or cabinet, remove it.
3. Remove the rack mount brackets from the side of the system (see
FIGURE 4-3
).
FIGURE 4-3
Removing the Rack Mount Brackets
4. Place the unit at an ESD station and use an anti-static wrist strap.
5. Remove the system’s top cover (see
FIGURE 4-4
).
a. Remove the screw at the rear center of the unit.
b. Slide the top cover back and lift it off.
SysAdmin.book Page 24 Friday, March 30, 2001 2:38 PM