Step 4:
Attach the Wheel (F) and braked wheel (G)
on the Support frame (C) and tighten with wrench
(DD).
Note:
Two braked wheel (G) should be assembled
in front of the service cart (the same as the pull
direction of Basket).
Step 3:
Put the Table top (A) upside down. Connect
assembled Support frame (C) and Table top (A) with
bolt (AA) and flat washer (
CC
). Then fully tighten all
the bolts by using wrench (
FF
).
Step 6:
Turn over the whole assembled piece. Place the Cutting board (B) onto the Basket (D) to the rear of the
drawer behind the stopper. This will prevent the cart from tipping. Please make sure to keep the cutting board
behind the topper.
