Summit TX25H, Operator'S Manual

Page: 79 / 93

General Maintenance of Electrical System
Lastly when you are cleaning the tractor and using the
pressure spray, take care not to damage the connections
on the various electrical cable.
Never patch up the electrical circuits.
Never replace a blown fuse by a higher capacity fuse. It
could cause a fire.
Never work on components such as the alternator or
starter motor when the engine is running.
Battery and Maintenance
Battery Capacity: 12V, 65 Ah
Check Electrolyte Level
It must be as per the recommendation of battery
manufacturer. If required, top up with distilled water just
touching the ‘Max’ mark on the battery . Electrolyte level
should never be below ‘Min’ mark. Never add acid.
Check Carefully Battery Charging
Protect against freezing. Insure that terminals are clean and
tight. Check specific gravity of battery using a battery
hydrometer. Specific gravity of a fully charged battery is
1.265 ±0.005 at 80.6 F[27 °C ]. °
Battery Removal Procedure
2. Remove fly nut by rotating it counter-clockwise.
3. Detach the negative (-) & po) terminals.
Battery is located at front of the tractor as shown in the
figure, follow the below procedure to access the battery:
1. Open the hood.
4.
Float
Electrolyte
surface
Electrolyte
Glass tube
B a t t e r y p o s t s , t e r m i n a l s , a n d r e l a t e d
accessories contain lead and lead compounds,
chemicals known to the state of California to
cause cancer and reproductive harm. Wash
hands after handling.
WARNING
MAX
MIN
Remember to disconnect the cables before you
recharge the battery. It is advisable to remove
the battery from its location and to recharge it
well away from the tractor. The place of battery
recharge must be well ventilated.
WARNING
+
-
Change battery having more than 700 CCA for cold
weather operations beyond 14 deg F.