7. Before putting the lower hinge (2) into position, remove the bolt-pin (9) and
reverse the direction of the lower hinge. Then install the lower hinge onto the
left side of the lower frame with two screws (8).
8. Insert the bolt-pin (9) into the lower hinge (2).
9. Set the door into place making sure the door seats onto the lower hinge (2).
10. While holding the door in the closed position, secure the upper hinge (5) in
the top frame of the left side with two screws (1). Do not tighten the screws
until the top of the door is level with the counter top.
11. Install the hinge cover (6) on the upper hinge.
OPERATING YOUR REFRIGERATOR
Setting the Temperature Control
Your unit has only one control for regulating the temperature in the
refrigerator. The temperature control, or thermostat, is located at the back of
the unit.
The range of the temperature control is from
0
to
5
. The first time you turn
the unit on, set the thermostat to its highest setting, which is
5
.
After 24 to 48 hours, adjust the temperature control to the setting that best
suits your needs. The setting of
3
should be appropriate for home or office
use.
To turn the appliance off, turn the temperature control to
0
.
NOTES:
Turning the temperature control to the
0
position stops the cooling
cycle but does not shut off the power to the unit.
If the unit is unplugged, has lost power, or is turned off, you must wait
3 to 5 minutes before restarting the unit. If you attempt to restart
before this time delay, the unit will not start.
Chiller Compartment
This compartment is actually part of the refrigerator compartment and is not a
true and separate freezer. It can make ice cubes but may not keep ice cream
frozen or get cold enough to freeze foods safely. You can use a colder
thermostat setting to freeze certain foods, but other items in the refrigerator may
be affected.
The door of the chiller compartment is susceptible to breakage due to excessive
ice build-up. This part is not covered under your warranty. Be sure to defrost
when the ice reaches a thickness of 1/4".
8
