Installation
Instructions
Range
If you have questions, call 1.800.932.4267
or visit our Website at: www.summitappliance.com
• This product must be installed by a licensed plumber
or gas fitter.
• When using ball type gas shut-off valves, they shall be
the T-handle type.
•
A flexible gas connector, when used, must not exceed 3 feet
In the Commonwealth of Massachusetts
FOR YOUR SAFETY
Mobile Home - Additional Installation Requirements
The installation of this range must conform to the
Manufactured Home Construction and Safety Standard,
Title 24 CFR, Part 3280 (formerly the Federal Standard for
Mobile Home Construction, use the Standard for
Manufactured Home Installations, ANSI A225, 1/NFPA 501A
or with local codes.
IMPORTANT —
Save these instructions for local
electrical inspector’s use.
IMPORTANT —
Observe all governing codes and
ordinances.
•
Note to Installer
-
Leave these instructions with the
appliance after installation is completed.
•
Note to Consumer
-
Keep this Owner’s Manual and
Installation Instructions for future reference.
•
Note
-
This appliance must be properly grounded.
•
Servicer
-
The electrical diagram is in an envelope
attached to the back of the range.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
As with any appliance using gas and generating heat,
there are certain safety precautions you should follow. You
will find these precautions in the Important Safety
Information section in the front of this manual. Read them
carefully.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this range must conform with local codes, or
in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA.54, latest edition. In Canada,
installation must conform with the current Natural Gas
Installation Code, CAN/CGA-B149.1 or the current Propane
Installation Code, CAN/CGA-B149.2, and with local codes
where applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest edition
and Canadian Gas Association according to CAN/CGA 1.1
latest edition.
Mobile home installations require:
• When this range is installed in a mobile home, it must be
secured to the floor during transit. Any method of securing
the range is adequate as long as it conforms to the
standards listed above.
Do not store or use combustible materials, gasoline or
other flammable vapors and liquids in the vicinity of this
or any other appliance.
1.
Open windows.
2.
Don’t touch electrical switches.
3.
Extinguish any open flame.
4.
Immediately call your gas supplier.
If you smell gas:
TOOLS YOU WILL NEED
MATERIALS YOU MAY NEED
*Teflon: Registered trademark of DuPont
• Gas line shut-off valve
• Pipe joint sealant or UL-approved pipe thread tape
with Teflon* that resists action of natural and LP gases
• Flexible metal appliance connector (1/2" I.D.)
A 5-foot length is recommended for ease of installa-
tion but other lengths are acceptable. Never use an
old connector when installing a new range.
• Flare union adapter for connection to gas supply line
(3/4" or 1/2" NPT x 1/2" I.D.)
• Flare union adapter for connection to pressure
regulator on range (1/2" NPT x 1/2" I.D.)
• Liquid leak detector or soapy water.
• Lag bolt or 1/2" O.D. sleeve anchor (for concrete
floors only).
19
Summary of Contents for ACK54GASW
Page 29: ...Notes 29...
Page 30: ...Notes 30...
