PG 5
SETUP
4
1
2
SEAT
Your foam seat must be attached to the climber platform
before use. The straps and buckles are attached and buckled
on the bottom of the seat from the factory. Please unbuckle
before proceeding.
1.
Place your seat platform on a flat surface with the rear “V”
brace facing up.
2.
Position the seat inside of the seat platform frame.
3.
Wrap the seat strap webbing over the frame from the
inside out as shown in
figure 1
.
4.
Turn the three bar slide slightly sideways and push it
through the metal D buckle that is sewn onto the end of the
strap (
figure 2
).
NOTICE
The seat included with these treestands is removable
for storage.
DO NOT
leave your stand outdoors
when it is not being used.
RAPIDCLIMB STIRRUPS
Adjust the stirrups to fit your footwear at ground level. This
is done by loosening the wing-nut and sliding the stirrup up
or down the tube. Re-tighten the wing-nut once desired fit
is achieved. NEVER remove the wing-nut or stirrups. NEVER
slide the stirrup outside of the acceptable adjustment range
showed in
figure 4
.
WARNING
!
Replace all seat cushions every two (2) years or
sooner if damage or wear is present.
WARNING
!
Moving your foot placement closer to the tree changes
the leverage needed to adhere the platform to the tree.
Attaching the stirrups or placing your feet too close to
the tree may cause the platform to slide down the tree
which could cause serious injury or death. See figure 4
for proper foot location.
TRACTION STRIPS
1.
Peal the backing off of one of the supplied high
traction strips and apply to the center of the platform
run as shown in
figure 3
. Repeat for all 5 rungs.
3
4
ACCEPTABLE ADJUSTMENT RANGE
