PG 9
PAD AND SEAT ATTACHMENT
16.
SEAT CUSHION -
Slide the Seat Platform into the pocket sewn into
the Seat Cushion and tie-off the strings around the Seat Platform.
SHOOTING RAIL PAD -
Wrap the pad around the Shooting Rail assembly
and secure with the hook and loop strips. The pad ends should stop
close to the Arm Rests.
ARM REST PADS (4 pieces) -
Attach two pads around the TOP of the Arm Rest. Attach the other two pads around the
Connection Tube (between the arm rest) UNDER the seat platform. These bottom two pads will serve as sound dampers for the
flip up Seat Platform
!
CAUTION
DO NOT use the Gun Rest Bar as a hand hold while
climbing into or out of this stand.
FINAL TIGHTENING
15.
Go back through and tighten all bolts and lock nuts securely.
Note: Do not overtighten the bolts where the tubes become deformed.
LADDER SECTION ASSEMBLY
14.
Assemble the remaining Ladder Sections together. Insert the “male” end of the Ladder Section into the “female” end of
the opposing ladder section. Secure the two sections together using (2) 35mm (Grade 10.9) bolts per side. Secure tightly.
See
figure 20 and 21.
20
21
WARNING
!
The foam seat included with this treestand is
removable for storage.
DO NOT
leave your seat
outdoors when it is not being used. Replace seat
cushion every two (2) years.
