28
28
30
CLIMBING UP WITH YOUR NEW STAND
ALWAYS refer to the written safety harness
instructions for proper use of your safety harness.
If you purchased a Razor SD, you must first position
the climbing bar in order to sit on it and climb.
Position the climbing bar so that the keyhole slot in
the support strut will fit over the head of the bolt as
shown in
figure 32
. Now slide both support bars - at
the same time - over the bolts and completely through
the keyhole slots as shown in
figure 33
. Now pull
down on the climbing bar (as it is already attached the
tree) to “seat” the bolts into the back of the support
struts (See
figure 34
). The climbing bar is now ready
to use.
1.
Following the Harness Instructions, attach the
harness tether to the safety strap. Loop the strap
around the tree to secure it. See
figure 35
.
2.
Your RapidClimb stirrups and bungee heel cord
should be already attached to your treestand. To use,
back your heel into the bungee heel cord (
figure 36
)
then simply slide your boot under the RapidClimb
stirrup. Make sure that your boot is secure under the
stirrup as shown in
figure 37
.
3.
On the Razor, hook the seat back elastic bungee
cord around the seat as shown in
figure 38
to keep it
secure while you climb.
4.
To begin climbing, raise your seat climber up to
just below waist height and grasp the upright arms
very firmly as shown in
figure 39 Razor and figure 40
OpenShot
.
WARNING
!
At this point IT IS MANDATORY AND REQUIRED
that you attach your safety harness to the safety
strap around the tree and remain connected at all
times after leaving the ground.
35
34
32
33
36
37
WARNING
!
DO NOT TIP YOUR WEIGHT ONTO YOUR TOES
unless you are ready to move the platform. This will
tend to disengage the platform from the tree.
31
CLIMBING UP / DOWN
(GROUP B STANDS)
6a
RAZOR
RAZOR
RAZOR
page 11
