10
Model SWC1102
1. Remove the door shaft assembly
2
by unscrewing the two lock screws
1
. Be careful to hold the glass
door firmly after removing the screws. (Fig. 1)
2. Gently pull down to remove the glass door from the right top hinge and place it on a padded surface to
avoid the risk of damage. Then remove the right top hinge
7
. (Fig. 2 & 3)
3. Pop out the cover caps on the left side of cabinet and use them to
cover the screw holes on the right
hand side.
4. Screw the alternative left top hinge
8
, included in the fittings,
on the left hand side of cabinet. (Fig. 3)
5. Unscrew and transfer the lower hinge bracket
5
and door supporter to the opposite side. At the same
time remove the stopper pin
4
to the opposite designated position of the lower hinge bracket. (Fig. 1)
6. Relocate the door shaft assembly to the designated position.
7. Relocate the glass door to the designated position. Then screw the door shaft assembly on the left
designated position and tighten it after the door is leveled. (Fig. 1)
8. Remove the handle from the left side of the door and install it on the right side. (
See below
.)
INSTALLING THE STAINLESS STEEL HANDLE
This appliance includes a stainless steel handle that is not required to
operate the unit. To install the handle, follow the instructions below:
Locate the handle
1
over the pins
3
of the door and tighten the handle
by screwing in screws
2
with an Allen wrench.
1
2
3
Summary of Contents for SWC1102
Page 19: ...19 NOTES...
