Operation
6
Operation
Normal Operation
During normal operation, the green
RUN
light (inside the
BOLUS
button) will
start to blink and the “
ml
” (volume infused) will appear in the Pump display.
Pause Infusion
To
PAUSE
the infusion, press and hold the
RUN/PAUSE
button for five (5)
seconds until one (1) beep is heard. The Pump will beep two (2) times, the
green
RUN
light will stop blinking, and the
PAUSE
(
l l
) icon will blink in the
Pump display. If left in
PAUSE
, the Pump will beep two (2) times every four
(4) minutes.
Note:
PAUSE
temporarily stops the infusion. While in
PAUSE
, the infusion is
delayed. This allows for changing the Cassette, solution container, or
batteries.
Resume Infusion
To resume the infusion from
PAUSE
, press and hold the
RUN/PAUSE
button
for five (5) seconds. The green
RUN
light (inside the
BOLUS
button) will
start to blink, and the “
ml
” (volume infused) will appear in the Pump display.
The infusion will resume at the same point at which the Pump was placed in
PAUSE
.
Silence Alarm
To silence an alarm, press and release the
RUN/PAUSE
button. When the
alarm has been silenced, the Pump will remain in
PAUSE
. Once the cause
of the alarm has been corrected, press and hold the
RUN/PAUSE
button for
five (5) seconds to resume the infusion.
Note:
If the Pump alarms due to downstream pressure (occlusion alarm), and the
cause of the alarm is corrected without intervention, the alarm will silence
and the Pump will resume the infusion automatically.
Bolus Activation
The
BOLUS
button is located on the Pump directly below the
RUN/PAUSE
button. Every time the
BOLUS
button is pressed during the infusion, the
Pump will beep once. If the bolus dose is permitted, the Pump will begin
bolus administration. During bolus infusion, the green
RUN
light will double
blink. If the
BOLUS
button is pressed during the Bolus Lockout Time, the
Pump will beep once, but no bolus will be delivered.
Pump Display
RUN/PAUSE
Button
BOLUS Button
