8
An automatic sensor stops ice making once the ice box is full. Remove the finished ice from the ice
basin to resume the automatic ice making operation.
Ice Thickness Sensor
An ice bridge thickness of 3.2mm (.012
”) is set as the factory default. Rotate
the control screw counter-clockwise to make the ice bridge thinner, and
clockwise to make the ice bridge thicker.
Changing the Purification Filter
When the purification filter is no longer active, the ice maker will not produce
ice. The filter cycle is typically 6 months, but might be shorter, depending on your environment and
quality of your water. Replacement filters can be ordered online at
summitappliance.com/filter100.
To change the filter:
1. Remove the inactive filter by turning it counterclockwise and pulling it out of the filter hole
2. Discard your old filter.
3. Insert the new filter, turning it clockwise until it is locked in place.
4. Always check for leaks upon first turning the ice maker back on.
CLEANING
Occasional cleaning and maintenance are necessary to maintain proper functionality and sanitary
conditions. Perform this cleaning process approximately once per month. Remove all of the ice from
the ice basin before attempting to clean the interior of the ice maker.
CAUTION: Unplug the ice maker before cleaning or replacing any part of the appliance. Spraying or
applying water to the appliance while plugged in may cause product failure or electric
shock.
DO NOT use powdered soap, benzene, muriatic acid, petroleum, boiling water, or a touch brush
because they can cause abrasive damage.
Cleaning the Ice Basin
1.
Set the power switch to the “OFF” position.
2. Unplug the power cord from the wall outlet.
3. Close the water intake valve.
4. Open the door and remove the drain plug on the bottom of the ice basin.
5. Rotate the three bolts on the bottom of the basin counter-clockwise to release them, pull out the
drain hose from the drain hole, and remove from the water tank.
a. Remove the ice sensor from the distributor.
b. Remove the two screws on the left and the right of the distributor.
6. Dilute 10g (0.35oz) of a neutral detergent, such as baking soda, in 3L (0.8gal) of warm water.
Soak a clean cloth in the liquid, wring out, and wipe the ice basin and water tank.
7. After cleaning, wipe everything with a clean, dry cloth.
8. Connect the drain plug, drain hose again, and tighten the three bolts again.
WARNING:
The surface temperature of the pump motor is very hot. Wait until the
appliance is cool enough, after turning off the power, before cleaning. Cleaning before the
motor has cooled may result in burns if contact with the skin is made.
