Summers DK9630, Operator'S Manual

Page: 75 / 82

CD1/8K/8K1850
SUMMERS MFG. CO., INC.
3/23/15
INSTALLATION AND OPERATION
INSTRUCTIONS FOR 8K1850
HUBODOMETER W/ HOUSING
FOR SUMMERS DIAMOND DISK AND 2510 DT
Attach HUB ODOMETER to gang nut as shown in photos
with 3/8” x 4-1/2” bolt, flat washers and lock nut. To prevent
loosening, rotate gang to insure that bracket is on center and
spot weld at locations shown.
Position Hubodometer on inside of rear center gang. DO
NOT LOCATE HUBODOMETER BENEATH IMPLEMENT
WING HINGE OR AT WIDEST POINT OF MACHINE.
Hub Odometer will be damaged if installed in these locations.
The Hub Odometer is calibrated at 359 revolutions per acre.
Refer to chart below for conversion for your implement.
MACHINE
CONVERSION
FACTOR
Diamond Disk Width
Multiply by ___ for Acres
Covered
16’ .90
18 ½’ 1.04
21’ 1.19
21 ½’ 1.22
24 ½’ 1.37
25’ 1.40
28’ 1.58
28 ½’ 1.61
32 ½’ 1.82
38 ½’ 2.16
44 ½’ 2.49
47’ 2.63
DT9530 Width
16’ .86
18 ½’ 1.00
21’ 1.14
21 ½’ 1.17
24 ½’ 1.32
25’ 1.35
28’ 1.52
28 ½’ 1.55
32 ½’ 1.75
38 ½’ 2.08
44 ½’ 2.39
47’ 2.53
SECTION 4 - PARTS
4-29