Owner’s Manual
®
18
fig.29
fig.28
4.3 Adjusting the seat depth
The seat depth can be adjusted from 42cm – 50cm in 2cm
increments. To adjust the seat depth, unscrew the two cap
head bolts with a 5mm allen key on the bottom of the back
rest (on each side of the frame) where it attaches to the wheel-
chair frame. Remove bolts and slide the back rest horizontally
along frame to desired position. Replace cap head bolts and
tighten (see fig. 28).
4.4 Adjusting the back rest angle
The back rest can be adjusted by 0°, 15° or 30°. Please note
that the back rest angle is the angle from the pre-set angle of
10.6°. The actual back rest angles are therefore 10.6°, 25.6°
and 40.6°. To adjust the back rest angle unscrew the cap head
bolts as per seat depth adjustment (see section 4.3), tilt the
back rest until the holes line up for either the 15° angle
adjustment or 30° angle adjustment, refix and tighten cap
head bolts (see fig. 29).
5.1 Frame number
To ensure the effective continuing service of your wheelchair
and to ensure your guarantee remains in place you must only
use authorised spare parts. The model and specification for
your wheelchair is on the label located on the lower part of the
left frame (see fig. 30).
5.2 Transport Kit for vehicles
Your Phönix wheelchair is suitable for use in an appropriate
vehicle provided the correct equipment is used to secure the
chair.
You can purchase a Transport Kit from Sumed International
(UK) Ltd. (see page 3 for contact details) which will provide the
necessary parts required for compliance with safety standards
in transportation of wheelchairs. The kit comprises of:
• 2 brackets which attach to the front of the chair as shown in
fig. 31. When a chair is ordered with a Transport Kit,
these will already be fitted. If a Transport Kit is ordered
separately, please refer to the instuctions suplied with the kit.
• 2 brackets which are attached as shown in fig.32.
As for the front brackets, these will be fitted when ordered
with a wheel chair. Please note that the Transport Kit cannot
be used with a seat depth of 48cm or 50cm.
fig.30
fig.31
Summary of Contents for PHONIX
Page 23: ...22 notes...
Page 24: ......
