Owner’s Manual
®
17
4.2 Adjusting the seat width (cont.)
4.2.4. Remove the two allen bolts at the top of the crossbar and pull out both inner tubes by the
same amount as the lower inner tubes. The upper inner tubes are provided with 6 holes, please
ensure that the amount of pulled out inner tubes above and below is the same.
Secure the left and right outer and inner tube of the crossbar with the respective hole of crossbar
connecting rail (e.g. seat width 59cm = 4th hole from outside, see fig. 27) in the bottom hole of the
crossbar.
Note: For all seat widths from 50cm to 65cm always use the lowest hole in the crossbar and the
corresponding hole in crossbar connecting rail for the desired seat width.
4.2.5. Attach the “hook and loop” straps to the seat and back rest and adjust them according to the
user's needs. Place the seat and back onto the “hook and loop” straps.
Note: Depending on the amount of width adjustment, an additional seat canvas and stabiliser bar
may be required.
Safety Note:
Before using the wheelchair, ensure all fixings are properly secured
fig.27
Cross bar
Cross bar connecting rail
Summary of Contents for PHONIX
Page 23: ...22 notes...
Page 24: ......
