Assembly Instructions MGB 1100 RD B
5/22
1.3
Assembling the central brake
Press the retaining washer (Pos. 19) into the groove of the brake shaft (Pos. 18).
Slide the plain washer (Pos. 28) onto the short end of the brake shaft, right up to the
retaining washer. Push the brake shaft (Pos. 18) with its long end through both
castors. With non-symmetrical castors please mind the direction of assembly. Screw
both castors with the brake shaft to the container in such a way that the retaining
washer and the plain washer are located on the inner side of the wall, between the
outer screw tubes. Slide the support (Pos. 20) onto the break shaft. Insert the locking
rod (Pos. 24) into the foot pedal and from below into the case of the lock. The lock
bolt must be open while inserting the locking rod. Plug the foot pedal (Pos. 21) onto
the brake shaft and fasten with the serrated lock washer (Pos. 23) and the hexagon
socket head cap screw (Pos. 22). The directional lock (Pos. 4, special equipment) is
attached to the left-hand castor.
2
5
18
19
4
28
20
24
21
23
22
