11
ENGLISH
Remote control
Syncing the receiver and the remote control for fan operation
If the receiver and transmitter of this fan are properly synchronized, the fan will work. During synchronization the receiver
recognizes the signal from the transmitter, this is called the learning process.
Make sure the fan is disconnected. This is essential for the synchronization process.
Unless the synchronization process has been successful, the fan will work partially or will not work. By default, all fans have
been preconfigured at the factory and should be functional once the installation is completed and the fan is turned on.
If the remote control does not work after installation or during use, synchronization can be performed as indicated below. Note
in any case that there could be other reasons why your fan or remote control does not work:
Make sure all connections are correctly made.
Make sure that the remote control contains batteries.
Make sure that all switches (main and isolation) are on.
Instructions for synchronizing the receiver and the remote control
This fan is pre-paired. In case of losing synchronization, there are two modes of synchronization: Universal Mode and Unit
Mode:
Universal Mode:
• This type of synchronization allows you to control one or more nearby fans with the same remote control.
• Synchronization:
1.-Connect the power (wall switch) of the fan or fans, and just then, within the next 5 seconds, press STOP for 5 seconds.
2.-A sound of type “beep” indicates that the connection is being executed.
3.-Inmediatly after this, press LOW button for 2 seconds.
4.-Now, the transmitter and receiver of the fan/s will have been synchronized. Remove the current of the fan/s by means
of the switch or
the breaker and after 10 seconds turn it/them on, this step is the one that closes the synchronization process.
Unit Mode:
• This type of synchronization allows you to control two or more nearby fans independently, each with its remote control.
• Synchronization:
1.-Connect the power (wall switch) of a single fan, and just then, within the next 3 seconds, press STOP for 5 seconds.
2.-A sound of type “beep” indicates that the connection is being executed.
3.-Inmediatly after this, press LOW button for 2 seconds.
4.-Now, transmitter and receiver of the fan/s will have been synchronized. Remove the power of the fan using the switch
or the breaker and
after 10 seconds turn it on again, this step is the one that closes the synchronization process.
5.-To synchronize another fan and remote control, you must disconnect the power or turn off the wall switch (if not shared
with the new fan to be synchronized) of the fan already synchronized and connect only the fan you want sync up. Then repeat
the points from 1 to 3.
2H
4H
1H
MED
HI
STOP
LOW
Light
ON/OFF
Turn on / Turn off light
Change color temperature
Turn off fan
Medium speed (Speed 2)
High speed (Speed 3)
Low speed (Speed 1)
Timer 1h
Timer 2h
Timer 4h
Mute sound control
STOP
MED
LOW
HI
LIGHT
ON/OFF
4H
2H
1H
