Gain
Operates as an overdrive and a volume control.
This is
responsible for adding harmonic sustain, richness and
depth at higher gain settings.
Presen ce
(pull Gain)
Located on the Gain control, this adds high frequencies by
altering the power section’s negative feedback.
Tr e b l e
Adjusts the boost and cut of treble frequencies. When
control is set to “5”, treble response is considered flat.
B r i g h t
(pull Treble)
Located on the Treble control, this provides an additional
boost of treble for a glassy edge to your sound.
B a s s
Adjusts the boost and cut of bass frequencies. When control
is set to “5”, bass response is considered flat.
Mid-B oos t
(pull Bass)
Located on the Bass control, this adds thickness and
sustain for “fattening up” lead tones.
R e v e r b
Adjusts the amount of reverb effect that is added to the
original signal. Turning the knob fully clockwise will provide
the maximum reverb effect.
The power select switch offers the following three-positions:
30 Watts
:
Amplifier operates at half power.
OFF:
!
"
Power is switched off
60 Watts:
"
Amplifier operates at full power
NOTE: In 30-watt position, only the middle two 6V6 output
tubes are used.
S t a nd b y
(located on
the back)
With the Power switch in the OFF position and the Standby
switch in the Standby position, flip the power switch to ON.
Wait sixty seconds, then flip the Standby switch to the ON
position.* To power down, simply switch the power switch to
the OFF position.
* This will prolong tube life.
NOTE:
To avoid loud popping or damage, ensure the
amplifier is in the Standby position.
P o w e r Se lect Swi t ch
TONE CONTROLS
