On Value [0 to 127]
Specifies the on value of the control change or note
on message.
Off Value [0 to 127]
Specifies the off value of the control change
message. You can set this only if the assign type is
set to Control Change.
TRANSPORT BUTTONS
Operating the transport buttons will transmit either
control change messages or MMC messages,
depending on the assign type. For each of these
six buttons, you can specify the message that is
assigned, the way in which the button will operate
when pressed, the control change number, or an
MMC command. Change these settings using the
Software Editor.
Assign Type [Control Change/MMC/No Assign]
Specifies the type of message assigned to the
transport button. You can specify that the button
be disabled or assign a control change message or
MMC message.
Button Behaviour
Selects one of two types of behaviour for the button:
Momentary
A control change message with a value of 127 will
be transmitted when you press the transport button,
and with a value of 0 when you release the button.
Toggle
Each time you press the transport button, a control
change message with a value of 127 or 0 will
be transmitted alternately. You can’t specify the
button behaviour if the assign type is “MMC.” If
you’ve specified MMC, an MMC command will be
transmitted each time you press the button.
CC Number [0 to 127]
Specifies the control change number of the control
change message that is transmitted.
MMC Command [Transport Buttons/MMC Reset]
Selects one of the following thirteen types of MMC
command as the MMC message that will
be transmitted.
Stop
Play
Deferred Play
Fast Forward
Rewind
Record Start
Record Stop
Record Pause
Pause
Eject
Chase
Command Error Reset
MMC Reset
MMC Device ID [0 to 127]
Specifies the device ID of the MMC message.
Normally you will specify 127. If the device ID is 127,
all devices will receive the MMC message.
7
Summary of Contents for SZ-MINIPAD
Page 1: ...SUBZERO MINIPADMIDI CONTROLLER USERMANUAL SZ MINIPAD...
Page 9: ......
