45 Logan Ave S, Renton, WA 98057 – phone: 425-228-6831, toll free: 888-64METER
Page
2 or 4
www.SubmeterSolutions.com - [email protected]
3. Push the connector end of the cable through open hole at the bottom of NoWire and re-insert the access
plug. Attach the connector cover to the conector. Pull the cable most of the way through the hole and loop it as
shown.
4.Lift the serial connector end of the cable and plug it into the NoWire Com2 connector. Try to avoid touching
the components on the circuit board by holding the board by its edges.
5. Place the NoWire circuit board back in the case laying it down on top of the cable. Don’t force it. Adjust the
cable under the circuit board so it doesn’t bind on the components and metal antenna of the receiver board
underneath. Screw back in the mounting screws to attach the NoWire circuit board back into the case.
6. Re-apply all other wiring such as the power supply, pulse input wires, pulse output wires, etc. Don’t apply
power to NoWire yet.
