GT BBU Connections
1. Disconnect the Harness Power Cable
from the PinWoofer Amplifier and plug it
into the 5.5mm BBU Power Jack.
2. Connect the New Power Cable Stub to
the 2-pin header on the BBU observing
the polarity shown. (The image shows a
12in cable to minimize clutter.)
3. Plug the other end of the New Power
Cable Stub into the 5.5mm amplifier
power jack.
4. Connect the 3ft 3.5mm Male to 3.5mm
Male Cable from the BBU LINE_IN to the
PinWoofer GT Amplifier Line Out Jack.
(The image shows a 6in cable to
minimize clutter.)
5. Plug the 12ft Subwoofer Cable into the
SUB_OUT jack on the BBU.
6. The BBU LINE_OUT is unused.
7. CAUTION: Please examine the red and
black wire orientation at the header
labeled “2” – DO NOT reverse the wire
orientation – use care to ensure that the
red and black wires are as shown.