(21,1)
北米Model "SAV19110-A" EDITED: 2019/ 5/ 23
(green zone of the air gauge).
CAUTION
.
Do not run the air compressor for
more than 10 minutes as it can
get hot. Be careful not to get
burned.
.
If tire pressure does not reach
the green zone for 10 minutes,
this kit will be unable to seal the
tire. Contact your SUBARU deal-
er for help.
NOTE
.
After the compressor starts to oper-
ate, the air pressure will temporarily
rise to 45 psi (300 kPa, 3.0 kgf/cm
2
) or
higher. After about 30 seconds when
all of the sealant is inside the tire, the
air pressure will lower, representing
the air pressure in the tire.
.
In extremely low temperatures
−
22
8
F to
−
4
8
F (
−
30
8
C to
−
20
8
C), the
viscosity of the sealant increases and
the sealant will flow more slowly. In
such temperatures, bring the sealant
into the vehicle to warm it up before
use.
.
When mending the tire, if the air
pressure gauge is hard to read, turn
the compressor switch off once to get
an accurate reading.
5. While filling the tire with air, attach the
speed limit label on the position shown in
the illustration.
WARNING
Do not attach the speed limit label
in a position where the label hides
the warning lamp or on the steering
wheel. It may interfere with the
normal operation of the airbag and
lead to a critical failure.
6. Turn the air compressor power switch
off when the air pressure reaches the
green zone of the air gauge.
Remove the power plug from the acces-
sory power socket.
Remove the hose after filling the tire with
17
