Subaru S209 2019, Service Manual

Page: 102 / 297

FS-8
Wheel Alignment
FRONT SUSPENSION
NOTE:
Empty the trunk or luggage room, load the spare tire, jack and service tools, and fill up the fuel tank.
3) Set the steering wheel in a straight-ahead position, and stabilize the suspension by moving the vehicle in
a straight line for 5 m (16 ft) or more.
4) Suspend a thread from the wheel arch (point “A” in the figure below) and affix at a position directly above
the center of wheel.
5) Measure the distance between the point “A” and the center of wheel.
2. CAMBER
1) Place the front wheel on the turning radius gauge.
NOTE:
Make sure the ground contact surfaces of the front and rear wheels are at the same height.
(1) Wheel arch height (4) Front wheel arch height (7) Point of measurement
(2) Front fender (5) Rear wheel arch height (8) End of spindle
(3) Rear quarter (6) Flange bend line
Tire size
Wheel arch height specification mm (in)
(Tolerance:
+12 mm
–24 mm
(
+0.47 in
–0.94 in
))
Front Rear
265/35R19 359 (14.13) 351 (13.82)
FS-00655
A
A
(4)
(2)
(5)
(1)
(7)
(6)
(8)
(4)
A
(3)
(5)