Subaru Legacy Outback 2006, Owner'S Manual

Page: 121 / 456

3-14
Instruments and controls
Warning and indicator lights
Several of the warning and indicator lights
come on momentarily and then go out
when the ignition switch is initially turned
to the “ON” position. This permits check-
ing the operation of the bulbs.
Apply the parking brake and turn the igni-
tion switch to the “ON” position. The fol-
lowing lights come on:
: AWD warning light (if equipped)
: Seatbelt warning light (if equipped)
: SRS airbag system warning light
: Malfunction indicator lamp
: Charge warning light
: Oil pressure warning light
: AT OIL temperature warning light
(AT vehicles)
: ABS warning light
: Brake system warning light
: SPORT mode indicator light (AT
vehicles)
: Vehicle Dynamics Control operation
indicator light
: Vehicle Dynamics Control warning
light (if equipped)/Vehicle Dynamics Con-
trol OFF indicator light (if equipped)
: Cruise control indicator light
: Cruise control set indicator light
If any lights fail to come on, it indicates a
burned-out bulb or a malfunction of the
corresponding system.
We recommend that you consult your au-
thorized SUBARU dealer for repair.
„
Seatbelt warning light
and chime (if equipped)
NOTE
If your seatbelt warning device does
not operate as described below, it may
be out of order. We recommend that
you have the device inspected and, if
necessary, repaired by the nearest
SUBARU dealer.
T
Europe, Asia and Australia models
Your vehicle is equipped with a seatbelt
warning device at the driver’s and front
passenger’s seat.
With the ignition switch turned to the “ON”
position, this device reminds the driver
and front passenger to put on their seat-
belts by turning on warning lights in the fol-
lowing locations:
Driver: Instrument panel
Front passenger: Between map lights
100254