㸰
Installation procedure for
IMPREZA (from October 2016),
SUBARU XV(from April 2017),
FORESTER(from July 2018)
1. Cut out the pattern papers, attached
to the owner’s manual and installation
manual, along the cut line.Use each
corresponding pattern paper as follows:
IMPREZA and SUBARU XV on page 5,
and FORESTER on page 6.
2. A s shown in the illustration to the
r ight, align t he pat ter n paper wit h
t h e s i d e p a n e l , a n d s e c u r e w i t h
t a p e. T h e n, m a ke a m a r k at e ac h
m a r k e d l o c a t i o n w i t h a m a r k e r.
(Fig. 1)
As shown in the Fig. 1, make sure to align
the lower end of the pattern paper, indi-
cated with an oval, with the lower edge of
the side panel.
3. Remove the pattern paper, and drill a
hole at each marked location. (Fig. 2)
Be sure to attach a stopper to the drill bit
to prevent it from penetrating through the
product. Set the length between the stop-
per and the drill tip at approx. 5mm.
5mm
Stopper
4. Inser t the (2) bracket bet ween the
s i d e p a n e l a n d t h e f l o o r c a r p e t ,
and align the holes. Then, sec ure
with the (4) screws M5x20 (2 pcs.).
(Fig. 3)
Fig. 1
Side panel
Floor carpet
(2)Bracket
(4)Screw M5x20
FORESTER
Tape
Tape
Side panel
Maker (Mark x 2)
Pattern paper
ᅗ㸫㸱
ࢧࢻࣃࢿࣝ
ࣇ࣮ࣟ࢝࣌ࢵࢺ
ղࣈࣛࢣࢵࢺ
մࢺࣛࢫࢱࢵࣆࣥ㸰
㸦㹋㸳㸰㸮㸧
ࣈࣛࢣࢵࢺࢧࢻࣃࢿࣝ➃ᮎ
㝽ࡀ↓࠸ࢆ☜ㄆࡋ࡚ࡃࡔࡉ࠸ࠋ
㝽ࡀ࠶ࡿࠊᮏయྲྀᚋࢢࣛࡘࡃ
ྍ⬟ᛶࡀ࠶ࡾࡲࡍࠋ
㸟
ὀព
Electric drill
Drill 2 holes (φ5.5)
Check that there is no gap between the
bracket and the edge of the side panel.
Leaving a gap can cause the product to
come loose after installation.
CAUTION
Fig. 2
Fig. 3
Side panel
Pattern paper
Tape
T
ape
IMPREZA and SUBARU XV
Maker (Mark x 2)