Remove 2 screws from console bin.
Note: It is recommended to drill from the
underside of the console to prevent damage
to the console bin from the drill.
8
9
Using a 14 mm (9/16 inch) drill bit,
drill a hole in console bin, about 19
mm (¾ inch) from back edge.
¾”
Feed dock cable (C) through hole, leaving 8-9” in
the console bin. Secure cable to console bin with
grommet (H). Place console back in position as
shown in slide 7.
Tilt console back. Disconnect wire harness and
remove console from vehicle. Note: For STI
models, wire routing and connections will differ
slightly.
C
H
8”
Pry gently around edges to remove trim panel. For
STI models, disconnect electrical connection. Note:
Gear selector must be in “N” with parking brake
set, ignition off and vehicle on level ground. For
manual transmission vehicles, shift knob must be
removed by unscrewing in a counter clockwise
direction.
10
7
Route dock cable towards front of vehicle as shown. Dock cable should be routed behind HVAC
controls and up to the radio opening.
11
PART NUMBER
SPN0000267 A
ISSUE
v1.1
DATE
01/14/08
SUBARU OF AMERICA
PAGE
3/5
