Subaru 2015 XV Crosstrek, Owner'S Manual

Page: 127 / 572

tails. Also, the setting can be changed
using the multi function display. For
details, refer to
“
Hazard warning
flasher setting
” F
3-69.
&
Locking the doors
Press the lock/arm button to lock all doors
and rear gate. An electronic chirp will
sound once and the hazard warning
flashers will flash once.
If any of the doors (or the rear gate) is not
fully closed, the following will occur to alert
you that the doors (or the rear gate) are
not properly closed.
.
the hazard warning flashers flash five
times.
.
an electronic chirp sounds five times.
When you close the door, it will automa-
tically lock and then the following will
occur.
.
the hazard warning flashers flash once.
.
an electronic chirp sounds once.
&
Unlocking the doors
Press the unlock/disarm button to unlock
the driver
’
s door. An electronic chirp will
sound twice and the hazard warning
flashers will flash twice. To unlock all
doors and the rear gate, briefly press the
unlock/disarm button a second time within
5 seconds.
NOTE
If the interval between the first and
second presses of the unlock/disarm
button (for unlocking of all of the doors
and the rear gate) is extremely short,
the system may not respond.
&
Unlocking the rear gate
Pressing the rear gate unlock button
unlocks the rear gate.
An electronic chirp will sound twice and
the hazard warning flashers will flash
twice.
&
Vehicle finder function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the
lock/arm button three times in a 5-second
period will cause your vehicle
’
s horn to
sound once and its hazard warning
flashers to flash three times.
NOTE
If the interval between presses is too
short when you press the lock/arm
button three times, the system may
not respond to the signals from the
remote transmitter.
&
Sounding a panic alarm
To activate the alarm, press the
“
PANIC
”
button once.
The horn will sound and the hazard
warning flashers will flash.
To deactivate the panic alarm, press any
button on the remote transmitter. Unless a
button on the remote transmitter is
pressed, the alarm will be deactivated
after approximately 30 seconds.
&
Selecting audible signal op-
eration (models without
“
keyless access with push-
button start system
”
)
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Perform the following steps to deactivate
the audible signal. You can also use the
same steps to restore the function.
1. Sit in the driver
’
s seat and shut all
doors and the rear gate.
Keys and doors/Remote keyless entry system
2-23
–
CONTINUED
–