Subaru 2000 Forester, Owner'S Manual

Page: 148 / 322

FORESTER U.S.A. (E)
10
Maintenance and service
10-9
– CONTINUED –
HS0176 HS0175
Drain plug
Sealing washer
Oil filter
6. Remove the under cover.
7. Remove the oil filter with an oil filter wrench.
8. Before installing a new oil filter, apply a thin coat of engine oil to the
seal.
9. Clean the rubber seal seating area of the lower crank case and
install the oil filter by hand turning. Be careful not to twist or damage
the seal.
10. Tighten it approximately two-thirds of a turn after the seal makes
contact with underside of the crank case.
CAUTION
Never over tighten the oil filter because that can result in an oil
leak.
11. Reinstall the under cover.
12. Pour the specified amount of engine oil through the filler neck.
Oil capacity: 4.2 US qt (4.0 liters, 3.5 Imp qt)
13. Start the engine and make sure that no oil leaks appear around
the filter’s rubber seal.
14. Run the engine until it reaches the normal operating temperature.
Then stop the engine and wait a few minutes to allow the oil drain
back. Check the oil level again and if necessary, add more engine oil.