Sub-Zero Wolf WWD30, Service Manual

Page: 20 / 32

Page 20
Component Access & Removal WARMING DRAWER WWD30
4-3
Stainless Steel Drawer Box
The side flanges of the stainless steel drawer box rest
on top of the drawer frame.
To remove the drawer box, begin by opening the drawer
until the stops are engaged. Then, at the center of left
and right side flanges lift drawer box.
(See Figure 4-1)
Drawer Removal
The drawer assembly rides on three slide assemblies,
one on each sidewall, and one underneath the drawer.
The slides extend until a stop is reached. The drawer
can be separated from the slide assembly by moving
the drawer release up for the left side and down for the
right and pull for the bottom.
(See Figures 4-2 & 4-2A)
Moving the drawer release allows the drawer to be slid
off the slide assembly. A control cable runs along the
right side the drawer and connects to the power board
behind cavity baffle on the rear wall.
To remove the drawer assembly, begin by opening the
drawer fully. Reach inside of unit cavity and disconnect
control cable from power board on the right side of cavi-
ty baffle. Release the control cable from the cable hold
down clips and place free section of control cable in
drawer. On outside of drawer with your index finger,
move the drawer release on side slide assembly.
(See
Figure 4-2) At the same time, push drawer slide back
into unit cavity until slide is past the stop. Repeat on
other side. Then, reach under drawer, pulling forward
on bottom drawer release, and pulling drawer forward
until slide is past stop.
(See Figure 4-2A)
Continue by pulling drawer off of slide assemblies.
NOTE: Upon reassembly control cable must be
arranged to avoid damage to cable.
(See Figure 4-7 & 4-8)
Figure 4-1. Stainless Steel Drawer Box Removal
Figure 4-2. Left Drawer Release
Figure 4-2A. Bottom Drawer Release
Lift Here
Lift Here
Pull
Drawer is heavy, use care not to damage drawer slides
or scratch frame of unit.