Page 27
Microwave Drop-down Door Series
Microwave Drop-down Door Series
Component Removal
3-12
#826151 - Revision A - March, 2016
LED Light Assembly
To remove the LED light assembly, first remove the
outer wrapper, then:
1.
Disconnect the wire harnesses from the control
board (See Figure 3-24).
2.
Remove the control board.
3.
Disconnect the wire harness from power module.
4.
Remove the power board.
5.
Use a T-10 Torx drive to extract the screws from the
bracket (See Figure 3-15 on page 3-8).
6.
Remove the bracket.
7.
Use a T-20 Security Torx drive to extract the
screws from the unit control support (See Figure
3-25).
8.
Rotate the unit control support so that the under-
neath is exposed.
9.
Use needle nose plier to compress the tip of the
wire retainers and push them out of the unit control
support.
10. Maneuver the unit control support around the wire
harnesses and remove the unit control support.
11. Disengage the rear tabs of the left and right air
separators from the fan mount.
12. Use a T-20 Torx drive to extract the screws from the
upper cover.
13. Remove the upper cover.
14. Use a T-20 Security Torx drive to extract the screws
from the right hand side chassis (See Figure 3-26).
15. Use a T-20 Security Torx drive to extract the screws
from the electronics mount.
16. Lift the left hand side of the electronics mount and
move it to the right and backwards. Rest the ele-
contronics mount on the magnetron.
continues on the next page
Figure 3-24. Boards Removed
Figure 3-25. Control Support and Separators Removed
Figure 3-26. Electronics Mount
Leftside Chassis
Right side Chassis
removed
