Sub-Zero Wolf CE Series, Service Manual

Page: 14 / 31

Page 14
Cooktop Electric (CE) Series
Cooktop Electric (CE) Series Electronics
2-10
#826496 - Revision A - May, 2015
Element Temperature: Built-in Thermal Limiter:
Each element has a built-in thermal limiter to protect the glass top. •
Thermal limiter will open between 1040° F and 1076° F. •
Thermal limiter will close at approximately 950° F. •
f. Error Code Indicator
Touch “+” pad during the Element Temperature test. •
Six “.” are displayed on left rear control zone. •
Front control zone shows 0-8 dimmed “.” based on how many error codes are logged. •
Fully lit LED indicates which error is being displayed in the 2-digit display. •
If only a single error has been logged, only a single fully lit LED is displayed. •
If no errors are logged SIM/MLT , HI , and “.” are not displayed and “- -” is displayed in the 2-digit display. •
2-digit display shows the corresponding error code stored in memory. •
Front left SIM/MLT and HI are dimmed. A touch of the front control zone SIM/MLT or HI pads cycles through •
the stored error codes.
Touch and hold
TIMER pad for 5 seconds to clear error code history. •
Clearing the error code history is only possible if at least one error was logged. •
Clearing the error code history is confirmed by a double beep. •
If an error is currently present when the log is cleared, it immediately regenerates an error code. •
“-” pad engages the Element Temperature test. •
“+” pad engages Showroom Mode menu. •
g. Showroom Mode
Touch “+” pad during the Error Code Indicator. •
Seven “.” displayed on left rear control zone. •
Touch the left front control zone HI pad to engage showroom mode. •
SH is displayed in the 2-digit display when in showroom mode. •
Touch the left front control zone SIM/MLT pad to disengage showroom mode. •
”-” pad engages the Error Code indicator. •
“+” pad engages the Software Version indicator. •
h. Software Version Indicator
Touch “+” pad during Showroom Mode. •
Eight “.” are displayed on left rear control zone. •
2-digit display cycles to show the software version of the control. •
“-” pad engages the Showroom Mode menu. •
1
2
3
4
5
Figure 2-3. Element Assembly Locations