Sub-Zero NANOCHILL NC-120A, User Manual

Page: 6 / 14

09 10
Sr.No. Parameter (LCD Message)
Description of parameters and functions.
Parameter setting method.
LIQ. PROBE CAL.
AFT PROBE CAL
EXAMPLE : If the actual temperature is
20.0ºC and the temperature on the
controller shows 22.0ºC set this
O
parameter to -2.0 C and once out of this
mode, the temperature will display
20.0ºC. (22.0ºC-2.0ºC).
Use UP/DOWN keys to set desired range.
During the course of time there may be a
slight offset in the actual temperature and
the temperature displayed.
Use UP/DOWN keys to set desired value.
EXAMPLE : Same as Main Probe Cal.
To change Main Probe Cal.
parameter, press the set key.
To change AFT Probe Cal.
parameter, press the set key.
11
12
Function : To set Main(Liquid) probe
calibration.
Function : To set Antifreeze probe
calibration.
-10.0ºC
-10.0ºC
10.0ºC
10.0ºC
0.0ºC
0.0ºC
AFT DIFFERENTIAL
To change the AFT Differential
parameter, press the set key.
10
Function : To set fault resetting
differential once it tripped of Aft set point.
Use UP/DOWN keys to set desired value.
EXAMPLE : If the AFT set point is set at
5.0ºC and differential is set to 2.0ºC then
after tripping on AFT fault controller will
clear the AFT fault only when the AFT
Temperature goes above
7.0ºC(5.0ºC+2.0ºC).
1.0ºC 10.0ºC 2.0ºC
Range
Min Max Fact. Set
Range
Min Max Fact. Set
Range
Min Max Fact. Set
Sr.No. Parameter (LCD Message)
Description of parameters and functions.
Parameter setting method.
Use UP/DOWN keys to set desired
value.
EXAMPLE : Same as Main Probe Cal.
To change Cond Probe Cal.
parameter, press the set key.
Range
Min Max Fact. Set
-10Amp 10Amp
0Amp
CURRENT CAL.
Once out of this mode controller will
display 10A.
Use UP/DOWN keys to set desired value.
EXAMPLE : If the actual current is 10A
and if controller is showing 9A ,then set
this parameter to 1A.
To change CT Cal.
parameter, press the set key.
14
Function : To set CT sensing calibration.
Range
Min Max Fact. Set
0
-10 C
0
10 C
0
0 C
COND PROBE CAL.
13
Function : To set Condensor probe
calibration.
15
Range
Min Max
0Min 99Min 20Min
HT POWER ON DLY Function : This sets Power ON delay for
high temperature alarm to avoid false
alarms.
To change HT Power On Dly
parameter, press the set key. Use UP/DOWN keys to set desired value.
Fact. Set
Disable Enable Disable
COND PROBE ACTIVE
control.
Use UP/DOWN keys to set desired value.
control.
Enable = Enables condensor probe
Disble = Disables condensor probe
To change Cond Probe Enable
parameter, press the set key.
16
Function : To enable or disable condenser
probe.
Range
Min Max Fact. Set
NC-120A NC-120A