WARNING :
Improper wiring may cause irreparable damage and personal
injury. Kindly ensure that wiring is done by qualified personnel only.
Maintenance :
Cleaning : Clean the surface of the controller with a soft
moist cloth. Do not use abrasive detergents, petrol, alcohol or solvents.
WIRING :
The probe and its corresponding wires should never be installed
in a conduit next to control or power supply lines. The electrical wiring
should be done as shown in the diagram. The power supply circuit should
be connected to a protection switch. The terminals admit wires of upto
2.5sq mm.
Controller
Controller should be installed in a place protected by vibration, water and
corrosive gasses and where ambient temperature does not exceed the
values specified in the technical data.
Probe
To give a correct reading, the probe must be installed in a place protected
from thermal influences, which may affect the temperature to be controlled.
CAUTION
The information in this document is
subject
to change in order to improve
reliability , design or function without prior notice and does not represent
a
commitment on the part of the company. In no
event will the company be
liable for direct, indirect, special, incidental or consequential damage
arising out of the use or inability to use the product or documentation, even
if advised of the possibility of such damages. No part of this manual may be
reproduced or transmitted in any form or by any means without the prior
written permission of the company.
Notice
18
CLAMP
96.00 mm
Max 6.00mm
65 mm
10.00 mm
Summary of Contents for MICRO CHILL
Page 1: ...www pvrcontrols com INDIA...
