Page 16
Hinge Cover
Remove two inner-most
screws at top and bottom
hinge with door open.
Remove two outer-most
screws at bottom hinge
first then at top, with door
closed.
Door
Assembly
Hinge Arm
400 Series
400 Series
Component Access and Removal
6-16
Figure 6-30. Door Assembly Removal
Figure 6-32. 427R Ref. Control Cable
Figure 6-31. 427R Drawer Removal
Pin
Drawer Slide
Hole in Drawer Channel
Drawer Assembly
Turn collar
counterclockwise
to disconnect
Collar
1
2
Door Assembly Removal (Models 427 & 427R)
The door is held in place with Allen-head screws that
pass down through the arm of the top hinge assembly
and up through the arm of the bottom hinge assembly
into the door frame. These mounting screws are con-
cealed by a hinge cover on each hinge arm. The hinge
covers are held in place by tabs that fit into notches in
the hinge arms.
NOTE:
See HEAVY DOOR WARNING at beginning of
To remove a door, begin by opening the door and
removing both hinge covers. With an Allen-head
wrench, extract the two inner-most door mounting
screws from the top and bottom hinge arms, leaving the
two outer-most screws in place. Now, close the door
and remove the outer-most door mounting screws from
the bottom hinge arm, then remove the two outer-most
door mounting screws from the top hinge arm, and lift
the door from the unit.
NOTE:
On the model 427R you will need to remove the
top drawer to access the door mounting screws at the
bottom hinge when the door is closed.
Assembly Removal (427R ONLY) below.)
Drawer Assembly Removal (Model 427R ONLY)
There are channels on both sides of a drawer tub in a
427R that rest on telescoping drawer slide assemblies.
A pin at the front of each drawer slide fits into a hole in
the drawer tub to hold the drawer assembly in place.
NOTE:
See HEAVY DOOR WARNING and ELECTRIC
SHOCK WARNING at beginning of this section.
The top drawer has a control cable that must be discon-
nected before drawer removal. To remove the top
drawer assembly, pull top drawer forward 6" to 10", lift it
up off of the pins at front and push the slides in.
Carefully place the drawer assembly face down directly
in front of unit. Then, disconnect the display cable at
interior left rear of the unit by turning the collar counter-
clockwise and unplugging the pins from the socket.
To remove the bottom drawer assembly, open the draw-
er and lift the front of the drawer up off of the pins at the
end of the drawer slides. Then, pull the drawer assem-
bly forward and out.
Upper and Lower Hinge Assembly Removal
(Models 427 & 427R)
The hinge assemblies are attached to the door with
Allen-head screws, and to a hinge mounting bracket
with Allen-head bolts.
