Suavinex Smart HU01/1, Instruction Manual

Page: 5 / 75

EN - 7
children. Make sure that the plug is correctly inserted into the
socket and that the power rating is compatible with the mains
electricity supply to which it is connected (see the plate on the
underside of the appliance).
8- Do not use plug adapters, socket strips and/or extension
leads.
9- Disconnect the humidifier from the mains before filling it with
water for use and before cleaning.
10- Do not move, lift, tip or perform any other cleaning or
maintenance operation while the humidifier is in use or plugged
into the power supply. Always unplug it before cleaning.
11- Before switching the humidifier on, it is recommendable to
rinse the humidifier and tank carefully with tap water.
12- Only use water at room temperature to fill the tank. Using
bottled mineral water or distilled water will extend the useful life
of the appliance and reduce the frequency with which it needs to
be cleaned to remove limescale.
13- In order to prevent electric shocks do not touch the plug or
the cable with wet hands.
14- Do not add any essential oil or aromatic substance to the
water in the base or the water tank. You can add a few drops of
essential oil to the essential oil tray.
15- When the appliance is not in use, empty the water from the
tank (before moving the appliance) to prevent microorganisms
growing in it. They can breed in the water tank and be dispersed
in the air, posing a serious health hazard. It is therefore
recommendable to change the water in the tank every 3 days
while the appliance is in use. After these 3 days, clean the
humidifier with tap water and remove any film that might have
formed on the surface of the tank. To prevent microorganisms
growing in the water more thoroughly, refill the tank with boiled
water and leave it to cool to about 40ºC.
16- Do not clean the appliance while in operation or just after it
has been on.
17- High levels of humidity can promote the growth of
microorganisms in the environment.
18- Ensure that the area where the humidifier is situated does
not get wet or damp. If it is excessively damp, point the mist
outlet in a different direction or even switch it off.
19- Do not use the product in wet environments such as the
bathroom in order to prevent possible electrical shocks and fires.
20- Place the humidifier in such a way that the mist from it is
not aimed directly at furniture, walls, curtains, rugs, electrical
appliances or other items that may absorb or be sensitive to
moisture. Beware! During normal operation of the humidifier,
surfaces near the mist outlet may become damp due to water
condensation (e.g. if there is a shelf just above it).
21- Place the humidifier at a height of at least 80 cm above the
floor to avoid condensation pooling on the floor.
22- Do not cover the mist outlet or the ventilation grid in the
base of the appliance with clothing or other items. The appliance
may overheat and stop working.
23- Certain basic rules must be observed when using any
electrical appliance:
- Do not pull on the power supply cable or the humidifier itself
to unplug it from the socket.
- Do not expose the appliance to atmospheric conditions such
as rain, sun, etc.
- Keep the appliance and the power supply cable away from
heat sources.
- Do not touch the appliance with wet or damp hands.
- Do not immerse the appliance in water or other liquids.
- Do not touch the appliance if it has fallen in water; should
this happen, cut off the power supply and unplug the power
supply cable from the socket before touching it. Do not use it
again until you have contacted the manufacturer, distributor or
authorised repair centre.
24- This appliance contains no serviceable parts that can
be reused by the buyer. Do not use accessories, parts or
components that are not supplied by the manufacturer,
distributor or authorised service.
25- If the appliance is faulty or does not work properly, switch it
off immediately and unplug it from the mains. Do not try to repair
it and contact the manufacturer, distributor or authorised repair
centre. Any repairs must be carried out by authorised technical
personnel.
26- Unplug the power supply cable while the device is not in use.
27- For fire prevention reasons, do not pass the power cable