ionCut 40 PADV
Copyright © Mundaka Welding & Gases, Inc.
8
3. Turn on the power switch, the power source lamp on.
4. Ready for cutting operation.
4.3 Cutting Operation
1. Turn on the power source.
2. Press on the cutting switch.
3. Pre-gas for 2 seconds
4. Ignite the pilot arc.
5. Shift to the work piece, the pilot arc change into cutting arc.
6. Perform the cut.
7. The torch leaves the work piece, the cutting arc change into pilot arc.
8. Loose the cutting torch switch.
9. Arc extinguished.
10. Post-gas for 30 seconds.
5. Maintenance
5.1 Cutting gun maintenance
Warning:
1. Check the consumable parts, if damaged, replace them.
2. Turn off the power source before check or remove cutting gun parts
Note: When operating the torch in a normal condition, a small amount of gas vents through the
gap between the shield cup and the torch handle, do not attempt to over tighten the shield cup
as irreparable damage to internal components may result