- 5 -
OPERATING INSTRUCTIONS
1. Connect the power cord to the bottom of the side handle on the
unit and plug the other end into the electrical outlet
(110/120V 60 Hz only)
2. Load the chamber with the ingredients (see below based on what
type of infusing is being done).
3. Place the head unit securely on top of the pot (unit will not turn
on if this is not placed securely). The LED display will light up
indicating the unit is on.
4. Press the select button to choose the desired MODE (Oil, Butter,
Tincture, DIY, Clean)
5. If the Preset time and temperature settings are being used (see
chart below), then press START.
6. If you wish to customize the time, press the TIME+ or TIME-
button on the digital control panel until the preferred setting is
reached. If you wish to customize the temperature, press the
TEMP+ or TEMP- button on the contorl panel until the preferred
settings is reached. Then press the START to confirm the settings
and begin the infusion.
Note: The unit will start to heat up at this point. The blade does not start
to spin immediately.
Note: If at any time while the unit is running you need to interrupt it you
can hold down the START button for 4 seconds. This will stop
the cycle that is in process and reset the unit. Once the unit is
stopped you can remove the top.
7. The red LED at the top of the side handle will illuminate. This
indicates that the unit is running and should not be disturbed.
During this time the LED digital display will count down the time
remaining.
Note: The blade does not run continuously while the unit is running. The
unit works with a combination of heat and blending, the blade
spins on and off throughout the cycle.
8. When the unit has completed its cycle the LED will turn green and
the LED digital display will read END – indicating that it is done.
