StumpJumper EVO ALLOY, User Manual

Page: 18 / 33

15
SEATSTAY @ LINK
M
L
M
M
L
M
5.9
Fig. 5.9
„
Grease, then place the seatstay spacers (x4) against the link bearings (tapered surface
against the bearing).
„
Align the seatstay with the link bearings.
„
Grease the non-threaded part of the bolts, then thread the seatstay bolts (x2) into the
seatstay bores.
„
Use a 6 mm hex key to torque the bolts and axles to 180 in-lbf / 20 Nm.
HORST LINK (DROPOUT)
D
D
E
G
G
F
F
G
G
E
5.8
Fig. 5.8
„
Grease, then place all the inner spacers (x4) against the Horst link bearings (tapered
surface against the bearing).
„
Align the flip chip spacers in either "high" or "low" position and place them against the
frame. The chainstay protector must be assembled prior to installation.
„
With the flip chips assembled, install the bolts. Make sure both drive-side and non-drive-
side flip chips are aligned in the same direction!
„
Use a 5 mm hex key to torque the bolts to 90 in-lbf / 10 Nm.
„
For instructions on adjusting the flip chip please see section 7.