background image

3

1.   Introduction

Thank you for buying the Studiomaster Professional Flex 3, 21” Gooseneck Microphone set.
To ensure maximum performance and safety, please follow this instruction manual carefully.
Please retain this manual for future reference.
For any complaint, feedback or testimonials please contact our distributor / dealer.
After unpacking the product, please inspect for any physical damage.
In the event that damage has occurred, immediately notify your dealer.
Retain the cartons/packing box for future use should the product require servicing/maintenance.

 

2.   Features at a Glance

•     Professional high quality 21” gooseneck microphone.
•     Sleek and unobtrusive design.
•     High sensitivity allows superior vocal reproduction.
•     High gain before feedback.
•     Balanced XLR Connector.
•     LED indicator on microphone to indicate “Mic Active” status.
•     Supplied with Microphone Base with On/Off Switch & LED.
•     Works on ex48V phantom supply or 2 AA batteries.

3.   Product Components

Microphone (Flex 3)  ….................................................................................x 1
Microphone Base ................….....................................................................x 1
Pop Filter Foam   …..........................................................................................x 1

4.   Product Usage

Controls: 

1.   Capsule:

 To pick up the voice of the speaker.

2.   LED indicator :

 

Indicates the “Mic Active” 

        status.

3.

    

On/Off Switch 

: This switch is used to 

        activate or mute the microphone as required. 

4.

   The LED displays the status of the microphone.

Cables:

•      Make sure good quality, low noise shielded cables are used. Good cables ensure good signal 
        integrity. 

Connection/Wiring: 

Pin 1
Pin 2 
Pin 3 

Ground
Hot (+ve Phase)
Cold (-ve Phase)
 

Balanced XLR

General Installation Guidelines

•      Aim the microphone toward the desired sound source, such as the talker, and away from any 
        unwanted sound source, such as a loudspeaker.
•      Place the tip of the microphone within 15 to 30 cm (6 to 12 in.) of the desired sound source.
•      Always use pop filter foam to control ‘pop’ sounds & breathe noise.
•      If four or more microphones will be open at the same time, use of a conference mixer, such as 
        the Studiomaster Professional Vak 20, is recommended.

5.   Frequency Response Curve

Polar Pattern

Frequency Response Curve

0

30

60

90

120

150

180

210

240

270

300

330

Power Supply:

•      This microphone re48V Phantom Supply or 2 AA batteries to operate. 
        Inadequate power supply may result in poor performance & reduced dynamic range.
•      If your mixer does not have provision for phantom supply, please use an external phantom supply 
       unit like the Studiomaster Professional Phantom 11.
•      Always mute the sound reinforcement system before you switch on the phantom power supply.

Note:

 Studiomaster Professional highly recommends using the Flex 3 only with the supplied base. 

            Using the microphone with any other base may result in poor product performance.

1

2

3  

4

Reviews: