12
VMK88
plus
MANUAL
SLIDERS / KNOBS
PROCEDURE: SLIDER / KNOB PROGRAMMING
We will set up a SLIDER to behave like an analog mixer fader. Fader Down>min. volume. Fader
Up>Max. Vol. Programing KNOBS follows the Exact same procedure.
TIP: Unlike an analog mixer you might not want your minimum volume to be 0 (no sound).
You may just want a track to “sit” in the mix. Therefore you should choose a value greater than 0.
For example, you may want to “ride” a guitar part and not want its volume to dip below a certain le-
vel in the mix. In that case set the Min. to a value that sounds good. Then when you pull the fader
down you’ll still hear the guitar without having to worry about fader position.
You can reverse this example for Max Values also.
1)
PRESS
EDIT
2)
MOVE
SLIDER (KNOB)
In this example Move SLIDER 1
w/Bank A Selected
3)
PRESS
PAGE UP
In this example we’ll use
CTRL Change number 10.
You may adjust this to any
CTRL number you desire.
4)
PRESS
PAGE UP
Set the Value Min. to 0
5)
PRESS
PAGE UP
Set the Value Max. to 127
In this example when the Slider
is pushed UP it will increase to
the Maximum allowed
