Model 207 User Guide
Issue 3, March 2021
Studio Technologies, Inc.
Page 27
MODEL 207
eSPORTS CONSOLE
Specifications
Power Source:
Power-over-Ethernet (PoE):
class 2 (low power,
≤6.49 watts)
Network Audio Technology:
Type:
Dante audio-over-Ethernet
AES67-2013 Support:
yes
Dante Domain Manager (DDM) Support:
yes
Bit Depth:
up to 24
Sample Rate:
44.1 and 48 kHz
Number of Transmitter (Output) Channels:
4 (Main,
Talkback, Line In L, Line In R)
Number of Receiver (Input) Channels:
4
(Headphone Ch1, Headphone Ch2, Headphone Ch3,
Headphone Ch4)
Dante Audio Flows:
4; 2 transmitter, 2 receiver
Network Interface:
Type:
100BASE-TX, twisted-pair Ethernet, Power-over-
Ethernet (PoE) supported
Data Rate:
100 Mb/s (10 Mb/s and 1000 Mb/s GigE
Ethernet not supported)
Compatibility – Headset A:
single- or dual-ear
broadcast-style with dynamic or electret (low-voltage
DC-powered) microphone: pin 1 mic common; pin 2
mic; pin 3 phones common; pin 4 phones left; pin 5
phones right
Compatibility – Headset B:
CTIA™/AHJ configuration
(typically uses electret powered mic): tip phones left;
ring 1 phones right; ring 2 common; sleeve mic
Microphone Input:
Compatibility:
dynamic or electret (low-voltage
DC-powered) microphones
Type:
unbalanced
Electret Microphone Power:
5 volts DC via 2.21 k
resistor, selectable on/off
Impedance:
1 k ohms, nominal, microphone power off;
690 ohms, nominal, microphone power on
Gain:
24, 30, 36, 42, 48 dB, selectable
Frequency Response:
50 Hz to 20 kHz, +0/–2 dB
Distortion (THD+N):
<0.07%, measured at –20 dBFS,
22 Hz to 22 kHz bandwidth, 36 dB of gain
Dynamic Range:
>96 dB, A-weighted, 24 dB gain
Compressor:
Application:
applies to Dante main and talkback
transmitter (output) channels and sidetone audio
Threshold:
2 dB above nominal level (–18 dBFS)
Slope:
2:1
Status LED:
compressor active
Headset Headphone Output:
Type:
2-channel (stereo)
Compatibility:
intended for connection to stereo (dual-
channel) or monaural (single-channel) headsets with a
nominal impedance of 50 ohms or greater
Maximum Output Voltage:
3.8 Vrms, 1 kHz, 150 ohm
load
Frequency Response:
20 Hz to 20 kHz, –2 dB
Distortion (THD+N):
<0.002%
Dynamic Range:
>100 dB
Stereo Line Input:
Type:
stereo (2-channel), analog, unbalanced
Impedance:
10 k ohms, nominal
Nominal Level:
–16 dBu (–18 dBV) (0.13 Vrms)
Gain:
–3, 0, 3, 6, 9, or 12 dB, selectable
Frequency Response:
20 Hz to 20 kHz, +0/ –0.7 dB
Distortion (THD+N):
<0.008%, measured at 0 dB gain
Dynamic Range:
>105 dB, A-weighted
Connectors:
Headset A:
5-pin female XLR
Headset B:
3.5 mm 4-conductor TRRS jack,
per Japanese standard JEITA/EIAJ RC-5325A
Stereo Line Input:
3.5 mm 3-conductor TRS jack,
per Japanese standard JIS C 6560
Ethernet:
Neutrik NE8FBH etherCON RJ45 receptacle
USB:
type A receptacle (located inside Model 207’s
enclosure and used only for updating firmware)
Configuration:
requires Studio Technologies’
STcontroller software application
Environmental:
Operating Temperature:
0 to 50 degrees C (32 to
122 degrees F)
Storage Temperature:
–40 to 70 degrees C (–40 to
158 degrees F)
Humidity:
0 to 95%, non-condensing
Altitude:
not characterized
Dimensions (Overall):
4.3 inches wide (10.9 cm)
2.1 inches high (5.4 cm)
5.1 inches deep (13.0 cm)
Deployment:
intended for tabletop applications
Weight:
1.2 pounds (0.55 kg)
Specifications and information contained in this User
Guide subject to change without notice.
Summary of Contents for 207 eSports Console
Page 2: ...This page intentionally left blank...
Page 29: ......
