Transport, Storage and Disposal
3.2
Description
The device is a probe to be used for sensing the limit level of
electrically conductive liquid media, by contact.
•
When the medium makes contact with the sensor rods, this
creates a conductive connection which is evaluated by the
electronics in the connector head.
•
Sensitivity adjustment via the potentiometer
•
Device installed in the vessel so that it is perpendicular to
the surface of the medium
•
2-rod probe for indicating the minimum or maximum filling
level
•
3-rod probe in the following variants depending on the cir-
cuit board installed:
–
2-state control unit
–
Indicates the minimum and maximum filling level
3.3
Layout
1
2
3
4
Fig. 2
Layout (example)
1
Housing cover
2
Connector head
3
Process connection
4
Sensor rods
4
Transport, Storage and
Disposal
4.1
Unpacking and inspection on delivery
1. Unpack the device when received and inspect it for trans-
port damage and completeness.
2. Check that the information on the type plate agrees with
the order/design data.
3. Report any transport damage to the manufacturer immedi-
ately.
4. If fitted immediately:
Dispose of packaging material
according to local regulations.
–
If fitted at a later point: leave device in its original pack-
aging.
4.2
Transportation
Device should preferably be transported in the original
packaging.
4.3
Storage
NOTE
Material damage due to inappropriate storage!
Store the device properly.
1. Make sure the storage room meets the following condi-
tions:
–
Dry
–
Frost-free
–
Vibration-free
–
Not in direct sunlight
–
Storage tempe10 °C to +60 °C
2. Device should preferably be stored in the original packag-
ing.
4.4
Disposal
WARNING
Substances hazardous to health!
The device contains substances that are hazardous to health
and the environment if disposed of improperly.
Do not discard the old device in household waste.
1. When disposed of via the manufacturer’s return system:
–
If applicable, delete any personal data.
–
Keep the old device separate from household waste
and return it to the manufacturer.
2. In the case of self-disposal:
–
Remove battery.
–
Disassemble electronic parts and plastic parts.
–
Dispose of parts according to local regulations.
302 483
BA-2022.08.31 EN
CFP
5
