Maintenance
7.5
Installing
Install components concentrically and without tilting in
accordance with the markings applied.
DANGER
Danger to life and material damage due to magnetic field.
Make sure that personnel with pacemakers do not com-
plete work on the pump.
Secure the work place and if necessary cordon off:
–
Make sure that personnel with pacemakers keep a safe
distance of > 1 m.
–
Make sure that no magnetizable metal parts can be
attracted by the pump's magnetic coupling.
–
Make sure that parts of the magnetic coupling cannot
be attracted by the magnetizable metal parts.
Maintain a safe distance of at least 150 mm from the mag-
netic coupling for magnetically sensitive objects.
WARNING
Risk of injury due to heavy components!
Pay attention to the component weight. Lift and transport
heavy components using suitable lifting gear.
Set down components safely and secure them against
overturning or rolling away.
WARNING
Risk of injury during assembly!
Install spring-loaded components carefully (e.g. mechani-
cal seal, stressed bearing, valves etc.), as components can
be ejected by the spring stress.
Observe the manufacturer's specifications (e.g. for the
motor, coupling, mechanical seal, blocking pressure sys-
tem, cardan shaft, drives, belt drive etc.).
WARNING
Risk of injury during assembly work on the magnetic cou-
pling!
Use jacking screws to assemble the bearing bracket in
order to prevent a sudden moving together of the magnetic
coupling due to magnetic forces.
NOTE
Material damage due to incorrect dismounting/installation
of the pump.
Only specialist mechanics should complete dismounting/
installation work.
NOTE
Material damage due to unsuitable components!
Always replace lost or damaged screws with screws of the
same strength where required
Only replace seals with seals of the same material.
NOTE
Material damage, fragile components.
Install ceramic parts of the plain bearing and magnets of the
magnetic coupling with care, do not strike them or knock
them.
1. When installing please observe:
–
Replace worn parts with genuine spare parts.
–
Replace seals, inserting them in such a way that they
are unable to rotate.
–
Do not apply synthetic or mineral oil, grease or cleaning
agents to elastomer components.
–
Adhere
to
the
prescribed
tightening
torques
9.2.8 Minimum flow rate, Page 33).
2. Installing the pump:
–
in
reverse
order
to
the
dismounting
–
→
sectional drawing
3. Installing the pump in the system
300 092
BA-2018.08.21 EN
SHM
25
