- 9 -
Cont ...
c) First step is to decide where your preferred connection should be, either the
side or the rear of the tanks then mark the centre point location on both units
(200 and iBoost 200).
Note: Later models will have pre-marked centres on the tank.
Step 2 Fitting of the tank connector:
a) Mark 2 circles approximately on both tanks using the previous location as
their centres. One for the hole at 65 mm diameter and the other to add fitting
at 89 mm diameter.
b) Cut a hole in both tanks using a 65 mm diameter hole cutter using the centre
points marked previously. Take care not to allow debris to fall into the tank
and keep cut edge free from burrs and hole as near to size as possible.
c) Straighten the wire holder and pass through body as shown. Then, whilst
holding the wire in one hand, manipulate the flanged end of the body into the
hole. This is easily done if one lug is inserted at a time, turning the body from
left to right.
FRONT
BACK
65
100
BACK
260
65
Fig. 5
Side connection
Back connection (not supplied)
O
89
O
65
Fig. 6
Hole to be cut
Fig. 7
Body
Wire holder
OR