MultiSwitch Plus
- Extended Control
pg 4
Preset Mode
Release the footswitch. The LEDs on
MultiSwitch Plus will flash
GREEN
when
configuration is complete.
All outputs carry the same signal in this
mode.
Check the
Appendix
for instructions on
how to configure the connected pedal for
use in this mode.
Enter Preset Mode by holding down the
A
footswitch while connecting the TRS cable to
MultiSwitch Plus. The
A
LED will flash
RED
to confirm the selection.
Connect the included TRS cable to the
EXP
jack of the pedal you wish to control.
3
4
2
1
This mode adds the ability to select and bypass three presets on
supported pedals
.
1
Press a footswitch with an unlit LED to select that preset on connected pedals. Step
on the same footswitch again to bypass the pedals.
1
Check the
Compatibility Chart on pg.15
for details
and a list of compatible pedals.
NOTE:
These three presets correspond to MIDI
Program Change messages 1-2-3.
NOTE:
For Volante, this is equivalent to the
presets stored on playback buttons 2-3-4. For
Sunset and Riverside, these are independent
of the preset that is associated with the
FAV
footswitch, which is equivalent to MIDI PC# 0.
A
B
C
+
EXP
