Stryker Performance-LOAD, Maintenance Manual

Page: 17 / 46

T Trro ou ub blle essh ho oo ottiin ng g
IIn nd du uccttiivve e cch ha arrg giin ng g ssyysstte em m d do oe ess n no ott cch ha arrg ge e tth he e cco ott b ba atttte erryy
Inductive charging system does not charge the cot battery when you load the cot into the fastener.
N No otte e -- Before you service the cot, disconnect the vehicle’s battery starting with the negative lead.
1. Make sure that a S SM MR RT T Pak battery is used on the cot and that the cot is equipped with inductive charging hardware.
2. Verify proper connection between the anchor-to-vehicle cable and the inductive primary board.
a. Check for 12.8V to 15.6V at the P Pe errffo orrm ma an ncce e--L LO OA AD D end of the anchor-to-vehicle cable (6390-001-135)
connection.
b. If present, continue to step 3.
c. If not present, make sure that the vehicle meets the following electrical requirements: 12.8V - 15.6V, 15A fuse/
breaker and two conductor 10 AWG cable.
3. Reattach the anchor-to-vehicle cable to the mating side of the inductive primary board.
N No otte e -- Make sure that like-colored wires are connected (red to red; black to black).
4. After making the connection, verify proper functionality as follows:
a. Load a P Po ow we err--P PR RO O cot (with a S SM MR RT T Pak battery) into the fastener, make sure that the P Po ow we err--P PR RO O battery
indicator is OFF prior to loading the cot into P Pe errffo orrm ma an ncce e--L LO OA AD D.
b. If the unit is functioning properly, the cot light panel orb will turn on within five seconds of being loaded into
P Pe errffo orrm ma an ncce e--L LO OA AD D. The light indicates that the unit is receiving power and that the electrical installation is correct
and complete.
c. If the light panel orb does not turn ON, check all connection points and replace the inductive coil and/or the primary
board.
6392-009-002 Rev E.4 13 EN