Stryker Gynnie, Maintenance Manual

Page: 16 / 84

12. Reverse steps to install the supplied brake ring, caster, and wheel.
13. Apply and release the brakes to make sure that they work. Adjust as necessary (see Brake adjustment (page 12)).
14. Remove the bungee cords and lower the base hood.
15. Verify proper operation before you return the product to service.
A
B
C
D
E
F
G
F Fiig gu urre e 4 4 –– B Brra akke e rriin ng g rre ep plla acce em me en ntt
B Brra akke e a ad djju ussttm me en ntt
T To oo ollss rre eq qu uiirre ed d::
• 3/32” hex wrench
• Pry bar
P Prro occe ed du urre e::
N No otte e -- The flat on the thread of the stud must always be aligned with the set screw. The turn must be a full circle only.
1. Using a pry bar (A), compress the spring to relieve tension on the stud (Figure 5).
2. Using a 3/32” hex wrench, turn the set screw (B) one full turn counterclockwise to tighten the brake.
3. Using a 3/32” hex wrench, turn the set screw (B) one full turn clockwise to loosen the brake.
4. Verify proper operation before you return the product to service.
EN 12 1061-009-002 Rev A.0