Stryker Gynnie OB-GYN 1061, Maintenance Manual

Page: 19 / 87

Service Information
18
PNEUMATIC FOWLER ADJUSTMENT
Required Tools:
5/32” Hex Allen Wrench 1/2” Open End Wrench
Adjustment Procedure:
1. For easier access, move Fowler to 75
_
or higher.
2. Using a 1/2” open end wrench, loosen the nuts in the actuator arms on the end of the trip bar.
3. To adjust the Fowler, use a 5/32” hex Allen wrench to turn the Allen screws 1 to 2 turns counter−
clockwise if the Fowler will not move or 1 to 2 turns clockwise if the Fowler will not hold its position.
4. Retighten the nuts. Be sure the Fowler will travel from flat to 90
_
and down again and will hold its position
when weight is applied before returning the stretcher to service.
FOOT SUPPORT REMOVAL
Required Tools:
Phillips Screwdriver
Procedure:
1. Remove the Phillips head screw, washer and plastic insert on the support.
2. Remove the support toward the foot end of the stretcher through the pivot assembly.
FOOT SUPPORT PIVOT ASSEMBLY REMOVAL
Required Tools:
7/16” Open End Wrench
Procedure:
1. Remove the two 7/16” Nylock nuts and two carriage bolts holding the pivot assembly to the litter.
2. Remove the two 1/2” Nylock nuts and the two Allen head bolts going through the foot end litter bracket.
Tap the Allen bolts in toward the center of the stretcher to allow access to the pivot assembly.
Return to Table of Contents
Back to Table of Contents