Stryker 6370, Operation Manual

Page: 20 / 99

English
EN
1-14 6370-109-005 REV C www.stryker.com
Installation
Installing the floor plate (Continued)
To position the antler floor mounting plates:
1. Determine the desired position of the cot inside the vehicle to allow for proper clearance around the cot.
Note: Federal ambulance specifications regarding aisle width and attendant seating may affect positioning of the
mounting brackets. If specifications do not apply, the installer should be certain that there is adequate clearance for
proper patient access, traction splint projection, rear door closure, and so on.
2. Using the dimensions shown in Figure 1-8 on page 1-14 , locate and drill the points where the floor plates will attach.
12-5/8” (32 cm)
24.000
(Ref.)
(61 cm)
6-1/8”
(15,6
cm)
14-15/16”
(37,9 cm)
37-5/8”
(95,6 cm)
80.000 (Ref.)
(203 cm)
2-5/8”
(6,6 cm)
14-5/8” (Ref.)
(37,1 cm)
A
B
C
D
E
F
G
Figure 1-8: Floor plate installation locations
A
Rail support bracket floor plate
E Cot center line
B Wall of vehicle F
Cot perimeter
C
Antler floor plates
G Cot head end
D Rear of ambulance
3. Cut 1 in. x 2-1/2 in. x 9/16 in. deep recessed openings (A) into the floor centered over the locating holes ( Figure 1-9
on page 1-15 ).