16
6086-009-001 REV B
www.stryker.com
Setup Procedures
Ensure that all shipping and packaging materials have been removed from the products prior to use.
Unpack the cartons and check all items for proper operation. It is important that the cot is working properly before it
is put into service. See “Figure 2: Cot Components” on
to identify all of the cot components.
Before placing the cot into service, check these components:
•
Check for loose fasteners. Replace if loose. Reference all assembly drawings.
•
All welds are intact (not cracked or broken)
•
No bent or broken tubing or sheet metal
•
No debris in wheels
•
All wheels are secure, and rolling and swivelling properly
•
Both siderails move and latch properly
•
Backrest operates properly
•
Optional accessories are intact and operate properly
•
Height positioning latch function operates properly
•
Cot secure in each height position (see
)
•
Undercarriage folds properly
•
Retractable head section operates properly
•
Safety bar operates properly
•
Foot rest operates properly
•
No rips or cracks in the mattress cover
•
Body restraints are intact and operate properly
•
Wheel locks operate properly (optional equipment)
•
Vehicle safety hook engages the safety bar so that the cot loads and unloads properly from the vehicle (see
)
•
Approved cot fastener (Stryker Model 6370/6377/6378/6379 or 6371 Cot Fastener − Not included) installed in the
vehicle (see
•
Adjust cot load height (see
)
The patient compartment of the vehicle in which the cot will be used must have a:
• Smooth rear edge for cot loading.
• Level floor large enough for the folded cot.
•
Stryker Model 6370/6377/6378/6379 or 6371 Cot Fastener System or Stryker Model 6390 Power-LOAD (not
included)
•
34” (86,4 cm) maximum loading height.
• Space to properly install the safety hook.
Note:
Loose items or debris on the patient compartment floor can interfere with the operation of the safety hook and
cot fastener. Keep the patient compartment floor clear.
When necessary, modify the vehicle to fit the cot. Do not modify the cot.
WARNING
•
Improper usage of the cot can cause injury to the patient or operator. Operate the cot only as described in this
manual.
•
Do not modify the cot or any components of the cot. Modifying the product can cause unpredictable operation
resulting in injury to the patient or operator. Modifying the product also voids its warranty (see
).
Summary of Contents for 6086
