Stryker 6082 RUGGED MX-PRO, Manual

Page: 28 / 105

Cot Operation
27
Changing the Height of an Empty Cot with One Operator
To raise/lower the cot from the foot end:
1. Standing at the foot end of the cot, grasp the
lower foot end lift tube.
2. Tip the cot up onto the load wheels (Figure 25).
3. Squeeze and hold the release handle and raise
or lower the foot end to the desired position.
4. Lower the cot back onto the four base wheels
(Figure 26).
To raise/lower the cot from the side:
1. Place one foot on the outer base tube.
2. Grasp the side release handle with one hand.
Place your other hand on the outer support rail
to help stabilize the cot (Figure 27).
3. Squeeze the side release handle and raise or
lower the cot to the desired position.
WARNING
If lowering the cot to the lowest position (position 1),
remove your foot from the base tube or injury could
result (Figure 28).
Figure 25 − Cot Tipped on Load Wheels
Figure 26 − Cot Lowered to Ground
Figure 27 − Holding Outer Support Rail
Figure 28 − Lowering Cot From Side